[categoryname]

Spiral Step Bracelet Project

Spiral Step Bracelet Project
B829

This project sponsored by:

1) Take one 10" length of wire and thread on one Crimp Tube (BD364) and the circle half of the Toggle Clasp (TC511). Take the wire around and back through the crimp tube. Pull the wire tight so that the wire cinches up to the connector loop on the toggle clasp. Crimp the tube closed with your Crimping Pliers (PL125), and cut any excess wire away with your Sidecutters (PL483). Repeat this step with the other length of the wire for the other connector loop on the circle half of the toggle clasp.

2) Start your beadwork for each length of wire
1
3mm Round Bead (BD303)
1
8mm Czech Fire Polished Black Diamond Round Bead (CZ8014)*
1
Hourglass Link (LK027)*
* Repeat again

3) String three Czech Fire Polished Black Diamond Round Beads onto one length of wire, string only one Black Diamond Round Bead onto the other length of wire. Thread one Spiral Bead onto each length of wire. Thread one more Round Bead onto the length of wire that has the three Black Diamond Round Beads on it, and thread three beads onto the length of wire that only had one Black Diamond Round Bead strung onto it at the beginning of this step. Thread one Hourglass Link (LK027) onto both length of wires.

4) Repeat step #3 again two more times.

5) Thread one Hourglass Link (LK027) onto both lengths of wire, then thread on one Black Diamond Round Bead (CZ8014) onto both wires. Repeat this step again.

6) Thread three 3mm Silver Plated Round Beads (BD303), and one Crimp Tube (BD364) onto each length of wire. Thread on the bar half of the Toggle Clasp. Take one of the lengths of wire around and back through the Crimp Tube. Pull tight so that the Crimp Tube cinches up to the connector loop on the Toggle Clasp, and so that all of the slack has been removed from that wire length in the bracelet. Crimp the Crimp Tube closed with your Crimping Pliers (PL125). Cut off the excess wire with your Sidecutters (PL483). Repeat this step for the other Crimp Tube on the other length of wire.

Quantity of Items Needed
6 Bead Spiral 8mm Pewter Antique Silver Plated (BD2019)
8 Round Bead 3mm Silver Plated (BD303)
4 Crimp Tube Seamless 2x2mm Silver Plated (BD364)
20" Beadalon Wire .018" 30ft Black 19 Strand (BW318)
32 Czech Fire Polished Rounds 8mm Black Diamond (CZ8014)
6 Hourglass Link 19x8mm Pewter Bright Rhodium Plated (LK027)
1 Heirloom 2-Loop Toggle Clasp 18x15mm Pewter Silver Plated (TC511)

Beautiful
I love this bracelet design very much, it's simple and beautiful.
Did you find this helpful?  1 of 1 Found Helpful
Reviewed by:  from USA. on 7/8/2020
5/5
There are no reviews for this product!

Buy Project Components

Recently Viewed Items

Top