Instructions.

1) Take one 3" length of beading wire and thread on one Bicone Pendant (CP6057) and one 25mm curved tube (TU134). Thread the ends of the wire through one Crimp Connector (CN902). Pull snug and crimp the connector with crimping pliers (PL125).

2) Take one 2" length of beading wire and thread on one Bicone Pendant (CP6031) and one 15mm curved tube (TU114). Thread the ends of the wire through another Crimp Connector (CN902). Pull snug and crimp the connector with crimping pliers (PL125).

3) Open the loop on the earring (SH114) with both chain nose and round nose pliers. Thread on the two beaded, curved tubes from steps #1 and #2. Close the loop on the earring.

To Finish.
4) Repeat all steps for the other earring.