[categoryname]

Strata Necklace Project

Strata Necklace Project
N2009

This project sponsored by:

1) Take the 20" length of wire and thread on one bead tip, a crimp tube and a 8/0 seed bead. Take the end of the wire around and back through the crimp tube and bead tip, then pull so that the seed bead cinches up to the bead tip. Crimp the tube closed and then roll the loop of the bead tip over after attaching the loop from one half of the tornado clasp and close the bead tip. Snip the excess wire off with your side cutters. *If the seed bead won't fit in the cup of the bead tip - crush the bead with your pliers to get rid of it.

2) Thread on a brown agate bead and then a petrified wood bead. Continue alternating between both of these beads until all of the beads are threaded on.

3) Thread on the other bead tip, crimp tube and seed bead. Take the wire around and back through the crimp tube and bead tip. Hold the necklace up so that the slack is removed and then pull so that the crimp tube cinches up in the bead tip. Crimp the tube closed with your crimping pliers and then snip away the excess wire with your side cutters. Attach the other half of the tornado clasp to the loop on the bead tip while rolling it into the bead tip. Close the bead tip. Done!

Quantity of Items Needed
20" Beadalon Wire .015" 30ft Bright Silver Color 19 Strand (BW015)
13 Petrified Wood Ovals 18x30mm (PW012)
14 Brown Agate Bead 6mm (BR106)
2 Bead Tip Clamshell Silver Plated (BD133)
1 Barrel Clasp 10x5mm Silver Color (BC413)
2 Crimp Tube 2x2mm Silver Plate (BD213)
2 8/0 seed beads (doesn't matter color)

There are no reviews for this product!

Buy Project Components

Recently Viewed Items

Top