1) Take the length of cord and thread on one half of the Toggle Clasp. Push it to within 3" of one end of the cord. Fold the cord tail over and make an overhand knot with the cord.

2) Take the wire, fold it in half and cut it. Take one half of the wire and make a "U" in the wire about 3/4" from the end of the wire. Slide this small wire tail into the overhand knot. Use your bent nose pliers to help you start wrapping the wire around the cord (both the tail and the remaining cord). Continue wrapping the wire around for about 1/2". Cut off the excess wire and cord tail. Make an overhand knot with the main cord.

3) Thread on a Decorative bead, and make another overhand knot in the cord (make sure you're knotting the same direction each time). Thread on a Horn bead, and make another overhand knot. Continue alternating between the decorative and horn beads with a overhand knot inbetween until all of your beads are threaded on.

4) After the last bead, make an overhand knot and thread on the other half of the Toggle Clasp. Fold the cord over and make an overhand knot around the main cord (hold it up against the other side of the bracelet to fold it over at the correct spot).

5) Take the other half of the wire and make a "U" in the wire about 3/4" from the end of the wire. Slide this small wire tail into the overhand knot. Use your bent nose pliers to help you start wrapping the wire around the cord (both the tail and remaining cord). Continue wrapping the wire around for about 1/2". Cut off the cord tail and continue to wrap the wire until it meets up with the other overhand knot.

Quantity of Items Needed
5 Bead Decorative 15mm Plastic Sterling Silver Plated Beads (BD2330)
4 Horn Beads Round Brown 16mm (HB9022)
12" Length of Leather Cord Brown 1mm (LC106)
1 Twisted Rope Toggle Clasp 14mm Sterling Silver (TC400)