Sparkling Mother of Pearl Necklace

Project Number: N599

This project sponsored by:

Instructions.

Take the two lengths of BC1011 and thread the ends through one BD194. Make a surgeon's knot and secure the bead tip against this. Put a small drop of GL527 on the knot and let dry completely before the next step.
Thread fourteen MP108 onto the two cords.
Start your beadwork.
- 1 Gold Plated Swarovski Rondelle (6mm/Silk)
- 3 Natural Mother of Pearl Round Bead (8mm)
Repeat two times
Start your beadwork.

Repeat four times
Repeat the pattern in step #3
Thread on the remaining fourteen MP108.
Thread the ends of the two BC1011 through the last BD194. Make a surgeon's knot and make sure the knot is snug against the clamshell. Hold the necklace up vertically if you need to check this. Secure the knot with a small drop of GL527, and allow to dry completely.
Close both BD194 with PL490. Open the two JR404 with PL491 and PL490. Attach one to either end of the necklace, through the loop on the closed clamshell bead tips. Before closing, attach one half of BC704 to either side. Close the jump rings.