Instructions.

1) Take each length of beading wire (BW615) and thread one Crimp Tube (CR2509) onto each wire. With one of the wires, thread on the round half of the Toggle Clasp (TC807) and then take the wire around and back through the Crimp Tube. Crimp this tube with your Crimping Pliers (PL125). Snip off the wire tail with your Side Cutters (PL495). Repeat this step with the other length of wire.

2) Take all three strands of different color pearls and take them off the strand into a small container. Mix them around a bit, because the stringing pattern is completely random. With on of the lengths of wire, thread on 21 pearls. With the other strand of wire, thread on 19 pearls.

3) Thread on one of the Copper Beads (BD874) onto both lengths of wire. With the length of wire that has 21 pearls on it (so far), thread 27 more pearls on, but make sure to put a Copper Spacer bead (BD218) inbetween each of the pearls strung in this section.

4) With the length of wire that has 19 pearls on it, thread 24 pearls on, making sure to include one Copper Spacer bead (BD218) inbetween each of the pearls strung in this section. 5) Thread the other Copper Bead (BD874) onto each length of wire. Keeping track of each wire, the length of wire that has 21 pearls on it in the first section will have 21 pearls on it in the last section to make the two sides even. String 19 pearls on the other length of wire so that this too matches the other side of the necklace.

6) Taking one of the lengths of wire (place a small amount of scotch tape over the other length so that the pearls don't accidentally come off.) thread on one Crimp Tube (CR2509) and the bar half of the Toggle Clasp (TC807) Take the wire around and back through the Crimp Tube. Pull the wire so that most of the slack is taken out (there may be a little wire showing where it comes out of the Copper Beads (BD874). This is pefectly alright and happens because of the size of the pearls used.) and crimp the tube closed with your Crimping Pliers. Cut the remaining tail off with your Side Cutters (PL495).


To Finish.

7) Thread the last Crimp Tube onto the other length of wire (remove the scotch tape if used) and thread the wire through the connector on the bar half of the Toggle Clasp. Take the wire around and back through the Crimp Tube. Cinch the tube up so that that slack is taken out and the loop created with the wire matches that of the other length of wire in step #6. Cut off any excess wire with your Side Cutters (PL495). Good Job!