Spots and Dots Necklace Project

Spots and Dots Necklace Project
N2019

This project sponsored by:

Quantity of Items Needed
QuantityItemItem ID
535mm Organic Laminated Sorghum Seed Barrel BeadOB330
205mm Brass Rondelle Heishi BeadsMB760
46mm Crystal Red Magma Briolette BeadsSD6601
14"20 gauge Gunmetal Artistic WireCW2013
28"2mm Natural Leather CordLC2031
25mm Antique Brass Plated Closed Jump RingsJR562
46mm Antique Brass Plated Open Jump RingsJR336
123mm Antique Brass Plated Hook & Eye Vine ClaspCL1161
Let's Begin
  1. Cut the wire length down into one 10" length and two 2" lengths.
  2. Make a wrapped loop on one end of the 10" length - make sure that the loop will be large enough to accommodate the 2mm leather cording. Thread on only one brass rondelle.
  3. Thread on one organic barrel bead, a brass rondelle, a briolette bead and another brass rondelle. Repeat this three more times and then thread on the last organic barrel bead and then the last brass rondelle. Make another wrapped loop with the remaining wire and snip away the excess.
  4. Cut the length of leather cording in half. Take one half and thread this through one of the wrapped loop and then fold this length of leather cording in half. Thread one of the closed jump rings onto both half of this leather cording. Bend the end of the leather cording in half at the 5-1/2" mark, making sure that the closed jump ring is in the "loop" created by bending the leather cord ends over on themselves. Pick up one of the 2" lengths of wire and wrap it around the whole set of wires (see the second picture above to see detail of this). Wrap around about four times and then snip the ends off and either tuck in the tail ends or cut it so that the wire ends won't irritate your neck as you're wearing this.
  5. Repeat step #3 for the other half of the necklace with the other closed jump ring, leather cording half and 2" length of wire.
  6. Open up the four jump rings and use two on each end of the necklace to attach the hook and eye clasp to each of the closed jump rings. Make sure that the jump rings are closed securely and done!
There are no reviews for this product!

Buy Project Components

Recently Viewed Items

Top