1) Take one of the 1' long lengths of wire and string one of the Briolettes onto it. Position the Briolette so that it's sitting right in the center of the wire, and then pull the ends of the wire so that they're right next to one another (forming a "U" shape with the wire). Take your Chain Nose pliers and pinch the two wires together just past the top of the Briolette.

2) Turn the Briolette and wire 90 degrees from the way that you were holding it before. In other words, if the both halves of the wire were facing you, by turning it 90 degrees, you'll only see one of the wires. Position your Chain Nose Pliers and make a 90 degree bend in the wire just above the top of the Briolette bead. Remove the Chain Nose pliers and replace with your Round Nose pliers. Make a wrapped loop with the two wires together, but don't stop when you reach the top of the Briolette, continue to wrap around the top and down the Briolette. Keep going until you have wrapped all of the wire. Trim off the excess with your Side Cutters.

3) Open the connector loop at the base of one of the Earwires. Attach the loop from the wrapped Briolette that you just created. Close the connector loop securely.

4) Repeat all of the steps to create the matching earring.

Quantity of Items Needed
2 Swarovski Briolette Pendant 6010 13x6.5mm Crystal Moonlight (BR6301)
2 Ear Wire Fish Hook with Coil 25mm Sterling Silver (SH505)
2 Round Wire 24ga Dead Soft Sterling Silver (SR124)
2 Standard Ear Back Surgical Steel (EN901)