1) Take one Hammered Oval Copper Ring (LK053) and one Hammered Gold Link (LK034). Open two Jump Rings (JR832) with your Chain Nose and Round Nose Pliers. Use each Jump Ring to attach one side of the Gold Hammered Link (LK034) to one of the connector holes on the Copper Hammered Oval (LK053). Close both Jump Rings securely. Open four more Jump Rings and attach two to each side of the Hammered Oval Link. Close these Jump Rings as well.

2) Repeat this step for the five remaining Hammered Copper Ovals and Gold Hammered Links. When you're done, pick up each of the Hammered Copper Oval Links and hold it horizontally at eye level. Looking at this link from the side, you'll note that there is a slight bend to the link itself. Make sure all of your links are facing the correct way (either bowing in or out).

3)You have two unattached jump rings on each side of each Copper Hammered Link. Split them so that there is one on each side of the link, so in this way, there is one jump ring on either side of the jump ring that attached the Gold Hammered Link to the connector hole on the Copper Hammered Link.

4) Open five more Jump Rings and use these to attach one link to another, through each set of two unattached jump rings that you set to each side of the Copper Hammered Link in step #3. Close each of these Jump Rings securely.

5) Open four more Jump Rings and attach two to each connector loop on each half of the Toggle Clasp (TC513). Close these jump rings. Open two more Jump Rings, and use each to attach the two jump rings from the Toggle Halves to the two free jump rings on the end link of the bracelet. Close these Jump Rings securely.

Quantity of Items Needed
47 Swarovski Cupchain 4mm Rose Peach Sterling Silver Plated (JR832)
6 Oval Hammered 13x9mm Link Pewter Bright Gold Plated (LK034)
6 Hammered Oval Drilled 25x17mm Link Pewter Antique Copper Plated (LK053)
1 Toggle Clasp - Hammered 22x16mm Pewter Copper Plated (TC513)