1) Take one of the Briolettes (FB1005) and one of the Pinch Vine Bails (BL109). Use your fingers to fit the hole on the Briolette into one of the posts on the inside of the bail. Close the bail with your fingers, and the other post should slip into the other hole on the other side of the Briolette.

2) Take one of the 2" lengths of wire and with your Chain Nose and Round Nose Pliers, begin to make a simple loop on one end of the wire, attaching it to the connector loop on the Pinch Vine Bail. Use your Side Cutters to remove any excess wire when making the loop. Thread one Olivine AB Bicone (AC4335) onto the wire, and then make another Simple Loop with the remaining wire (using your Side Cutters to remove all excess wire as well).

3) Open the connector loop at the base of the Earring the same way that you would a jump ring, and attach this opened loop to the Simple Loop that you just created in the previous step. Close the loop securely, and repeat all step to create the other earring.

Quantity of Items Needed
2 Swarovski Crystal Bicone Beads 5328 4mm Olivine AB (AC4335)
2 Bail - Vine Pinch 14mm Pewter Antique Copper Plated (BL109)
2 Copper Ear Wire 21mm (EW015)
2 Swarovski Flat Briolette 6012 11x10mm Ruby (FB1005)
4" Copper Dead Soft Wire Round 20ga (WC020)