Copper Falls Earring Project

Copper Falls Earring Project
E1040

This project sponsored by:

1)Cut the 32" of chain down into sixteen 2" lengths. Cut the ball end off of the two headpins.

2) Create a simple loop with the end of the headpin that you cut the ball end from. Before you close the loop completely, attach eight lengths of 2" chain onto the loop. Close the loop securely.

3) Slide a bead cap onto the wire so that the cup is covering up the simple loop. Slide another bead cap on the wire so that the small ends of both attached bead caps are touching. Attach a Briolette bead and another bead cap to frame the bead. Make a simple loop with the remaining wire and cut the excess off with your side cutters. Open up the loop at the base of one of the earwires and attach this to the simple loop you just created.

4) Repeat all steps to create the other earring.

Quantity of Items Needed
6 Bead Cap - Corrugated 5mm Base Metal Antique Copper Plated (BC1033)
32" Length of Spiral Chain 1mm Antique Copper Plated (CN859)
2 Lever Back Earrings 15mm Antique Copper Plated (EW029)
2 Head Pin with 2mm Ball 2" 22 gauge Antique Copper Plated (HP173)
2 Swarovski Briolette Bead 5040 8x5.25mm Caribbean Blue Opal (SD8394)

There are no reviews for this product!

Buy Project Components

Recently Viewed Items

Top