[categoryname]

Amber Rounds Bracelet Project

Amber Rounds Bracelet Project
B926

This project sponsored by:

1) Take the 10" length of beading wire and thread on one Crimp Tube and the circle half of the Toggle Clasp. Take the wire around and back down through the Crimp Tube. Pull the wire so that the tube cinches up to the connector loop on the Toggle Clasp. Crimp the tube shut with your Crimping Pliers. Thread the next couple of beads over the excess wire tail. Use your Crimping Pliers to close a crimp cover over the closed Crimp Tube.

2) Thread on one Round Horn Bead, a Squash Bead, and an Oval Horn Bead. Repeat this pattern until all of the Horn beads and Squash Beads are threaded on.

3) Thread on three 3mm Round Beads, the last Crimp Tube and the bar half of the Toggle Clasp. Take the wire around and back through the Crimp Tube. Pull so that all slack is removed from the bracelet and the Crimp tube cinches up to the connector loop on the clasp. Leave a small bit of room to fit a Crimp Cover over the Crimp Tube.

4) Crimp the tube shut with your Crimping Pliers, and cut the excess wire tail off with your Side Cutters. Close a Crimp Cover over the crimped tube. Done!!

Quantity of Items Needed
3 Round Bead 3mm Gold Plated (BD302)
2 Crimp Tube Seamless 2x2mm Gold Plated (BD363)
2 Crimp Covers 4mm Gold Color (BD544)
5 Round Disc Beads 15mm Gold Cara Horn (BD578)
4 Oval Flat Beads 13x18mm Gold Cara Horn (BD580)
8 Squash Bead 4mm Gold Plated (BD352)
10" Length of Beadalon Wire .015" 30ft Bright Silver 7 Strand (CW023)
1 Toggle Clasp 20mm Brass (TC521)

Simple
I like the simplicity of this bracelet.
Did you find this helpful?  0 of 1 Found Helpful
Reviewed by:  from USA. on 7/8/2020
5/5
There are no reviews for this product!

Buy Project Components

Recently Viewed Items

Top