Instructions. **** Hint ***** Stretch out BC1014 overnight by looping the cord over a shower
bar and tying the ends to a key ring that isn't too heavy but has some pull to
it. Do this the night before you wish to start the project and the cord will be
ready to go when you are!
1) Start your beadwork.
2
Seed Bead Crystals Silver Lines (6/0)
1
Atlas Beads Crystals (6x4mmmm)
(on every other seed bead grouping, thread one AC3001 between the two)
2) Repeat this pattern until you have 12 seed bead groupings. Leave 4" of
cord on either end of the threaded beads. Cut the cord with PL495 and seal all
ends with WX514.
3) Repeat step #1 two more times to create three strands of beads.
4) Braid the strands together.
5) Take one EP125 and one of the ends of each of the strands of beads. Making
a surgeon's knot for each, securely attach the cords to the eye pin. Repeat for
the remaining EP125 and the ends of the other half of the beaded cords. Secure
all knots with a small drop of GL527.
To Finish.
6) Thread each of the EP125 through each of the CN205. Make a wrapped loop with
the remaining wire that is sticking out of each of the cones. Before closing each
of the wrapped loops however, attach either the JR755 or the CL540 to either end.
